CVRDA

I am still struggling to replace the gooseneck on my 1974 Strale dinghy but think i might have a new lead and wondered if it might give any of you any further ideas ... I have done my best to try to decipher the makers plate on the mast. It is clearly "made in France" and the manufacturers...

If all else fails I guess that's right but would dearly like to track down the right part if possible

Annoyingly I cannot tell as it is so old and the plate has faded!

Andrew

Very much so but the pin or spright is too wide in diameter - I need one that is about 9mm

Unfortunately I do not have photos of the gooseneck itself. It was detachable. It did not break off but rather just fell off! I have measurements of the slot in the mast into which it fits and the socket in the boom into which the sprigot fits. The slot in the mast is approximately 20mm by 17mm (per...

My pride and joy is my Strale (an Italian designed dinghy from the 1970's). I was having a great time in a big wind the other day but somehow managed to lose the gooseneck over the side! I have searched high and low for a replacement but have had no luck at all ... nothing seems to fit. Does anyone ...

My pride and joy is my Strale (an Italian designed dinghy from the 1970's). I was having a great time in a big wind the other day but somehow managed to lose the gooseneck over the side! I have searched high and low for a replacement but have had no luck at all ... nothing seems to fit. Does anyone ...