Lifting veneer

share hints, tips and experiences
Post Reply
User avatar
Nessa
Posts: 2276
Joined: Sat Sep 27, 2008 3:16 pm
Location: East Angular

Lifting veneer

Post by Nessa » Mon Oct 13, 2008 1:14 pm

In amongst our fleet is an oldish wooden streaker. It is a nice boat but has suffered from a poorly fitting top cover which means that some of the varnish is lifting away around the shroud plates and taking the veneer with it. Clearly I need to deal with this, but what is the best way without damaging this veneer? I think the veneer will have become very brittle and may well snap or break off when I try to sand/scrape the varnish.

Thanks in anticipation.

Nessa
Yellow Peril
Agamemnon
Lovely little Cadet
Manky old Wayfarer
Stealth
Xena Warrior Princess
Finn 469

User avatar
Ed
Site Admin
Posts: 3472
Joined: Wed Sep 01, 2004 10:11 pm
Location: Plymouth
Contact:

Re: Lifting veneer

Post by Ed » Mon Oct 13, 2008 1:33 pm

If it is just the outer veneer of the ply.......

pull off anything that wants to come off easy.
cut back to good outer veneer
cut new bit of veneer
stick on
sand
varnish
admire

Just make sure the damage is to only the outer layer, otherwise you may have to think more about replacing the whole bit of ply.

Not sure what else to say...

you can sometimes stablise the inner core of ply with 'wood-hardener' 'thin epoxy SP300?', Blakes Woodseal or Bondamarine G4 well thinnned.

good luck

cheers

eib
Ed Bremner
CVRDA


Jollyboat J3
Firefly F2942
IC GBR314 ex S51 - 1970 Slurp
MR 638 - Please come and take it away
Phelps Scull
Bathurst Whiff - looking for someone to love it

Post Reply