Would it work?

share hints, tips and experiences
roger
Posts: 3026
Joined: Mon Sep 20, 2004 12:08 pm
Location: Frome Somerset UK

Re: Would it work?

Post by roger » Thu Jan 08, 2009 7:09 pm

Ed wrote:I think people remove them because they leak.....they are annoying and if you sail on a lake in lowish winds, tend to let more water in than out. And of course good ones are damn expensive.


eib
If the weather is light and you do have leaky bailers a few minutes under the boat with a little silicon sealant works wonders. If you need to use them you can easily break the seal but it does save the tedious sponging when you should be concentrating on sailing
Hornet 191 Shoestring,
Hornet 595 Demon awaiting restoration
Hornet 610 Final Fling
Hornet 353

User avatar
jpa_wfsc
Posts: 1186
Joined: Sun Dec 04, 2005 9:52 pm
Location: Oxford (Work) Coteswold Water Park (Sailing)

Re: Would it work?

Post by jpa_wfsc » Thu Jan 08, 2009 10:01 pm

My flat deck phantom came up from capsize with not too much water in even if I was standing on the board (I was about 13 1/2 stone then) and the self bailers cleared it very quickly (if there was enough wind to have capsized in the first place that is). The transom flaps were permanently taped shut.

Don't fit them too far forward - if you do, they will be useless because when planing (i.e. most of the time in a F4 or higher) the bow lifts, and the water will run back to the rear 1/2 oft he centerboard case. Also, theoreticaly at elast, you do not want a stream of air bubbles running down past the centerboard as it would stop it working much! And not too near the centerboard case either you don't want to weaken the floor there. Mine were where you could reach them by learning forward over the traveler bar.

Definitely fit two, big ones! Little ones are a waste of space. Mine were about 2" wide, orange plastic affairs, I have never seen them on any other boat so can not advise of the make. They did not leak at all when shut.

Enjoy sailing her - the phantom is so direct isn't it! Keep it very (very) flat all the time! And like all mono-sail single handers, don't pull the main into the centreline - the end of the boom needs to be at least in line with the inside wall of the tank when 'close hauled'. Your phantom will then pick up and zoom to windward in a very rewarding way!

john./

User avatar
Brookesy
Posts: 498
Joined: Tue Nov 01, 2005 12:14 am
Location: Grantham. Lincs.

Re: Would it work?

Post by Brookesy » Fri Jan 09, 2009 10:46 am

I will take a couple of pictures of my Phantom for you over the weekend as it is stripped in the garage. Mine does not have a double bottom but has large flaps and one large single elvestrom bailer on the port side quite well aft. It should be a well sorted boat as it originally was 'Mr Vandercrafts'.
GBR74 ex custodian of
GBR384 Mickey Finnale (Taylor,wood)
GBR455 Rubber Duck (Taylor, grp)
FD GBR350 Supercalifragalisticexpialidocious

User avatar
Nessa
Posts: 2278
Joined: Sat Sep 27, 2008 3:16 pm
Location: East Angular

Re: Would it work?

Post by Nessa » Fri Jan 09, 2009 11:41 am

That would be phenomenally helpful! Thank you! :D
Yellow Peril
Agamemnon
Lovely little Cadet
Manky old Wayfarer
Stealth
Xena Warrior Princess
Finn 469

Rupert
Posts: 6239
Joined: Thu Sep 16, 2004 8:40 pm
Location: Cotswold Water Park

Re: Would it work?

Post by Rupert » Fri Jan 09, 2009 1:16 pm

I think I might have a spare bailer somewhere in the shed - would you like me to have a look, or do you have that side of things sorted?
Rupert

Post Reply