sorry for the delay. Been away sailing!!!!!
Top Bearing is c.98mm by 38mm deep.
Also have bottom bearing c.77mm by 49mm deep
Bolt holes on top bearing plate for bolting to deck are at c. 170 mm centres
If you are still interested, pls let me know.
Regards, Craig
OK Deck Mast Bearing
Re: OK Deck Mast Bearing
Hi Craig, many thanks for the reply.
Whilst you were away I have managed to fashion up a top bearing from a plastic chopping board and a piece of scrap tufnol that I found. The hole diameter I cut was 98mm and so it sounds like your bearing would be ideal if this one proves no good. I'm currently in the process of repairing the centreboard and rudder but will try to get the boat on the water before the season end. Will let you know how I get on and once again thanks for coming back.
Whilst you were away I have managed to fashion up a top bearing from a plastic chopping board and a piece of scrap tufnol that I found. The hole diameter I cut was 98mm and so it sounds like your bearing would be ideal if this one proves no good. I'm currently in the process of repairing the centreboard and rudder but will try to get the boat on the water before the season end. Will let you know how I get on and once again thanks for coming back.
Rich